Jumper Settings - DFI-ITOX G7L630-B User Manual

Jumper Settings

Clear CMOS Data
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
c) You are unable to boot-up the computer system because the
processor's ratio was incorrectly set in the BIOS.
you can reconfigure the system with the default values stored in the
ROM BIOS.
To load the default values stored in the ROM BIOS, please follow
the steps below.
1. Power-off the system then unplug the power cord.
2. Set JP5 pins 2 and 3 to On. Wait for a few seconds and set JP5
back to its default setting, pins 1 and 2 On.
3. Now plug the power cord then power-on the system.
If your reason for clearing the CMOS data is due to incorrect
setting of the processor's ratio in the BIOS, please proceed to
step 4.
Hardware Installation
3
JP5
2
1
1-2 On: Normal
(default) Clear CMOS Data
2
3
2
1
2-3 On:
29