Thermostat Circuit Testing and Replacement
Continued from previous page.
Condition: Water heater not operating. Digital
display shows error code 80 high water
temperature (over 200°F) (continued from
previous page).
Once cause of overheating condition
has been diagnosed and corrected, the
control board may be reset.
•
Reconnect and switch on power to the water heater.
•
Press button under "Reset" and hold for 3 seconds.
•
Set thermostat to the desired setting.
•
Water heater will start.
•
Monitor temperatures for one complete heating cycle making
sure the maximum tank temperature remains below 207°F.
Service Procedure I:
23
WARNING
DO NOT operate the water heater without
verifying that the overheating condition has
been corrected.
23