Table of Contents
Advertisement
q
w
e
4
z x c v
q
e
r
w
t
w
y
u
q
Darning Stitch
q
w Thread tension dial: 3 to 6
e Presser foot:
Starting to sew
z Attach the automatic buttonhole foot R and pull the
button holder q all the way out.
Draw the needle thread to the left through the hole of
foot.
q Button holder
x Place the fabric under the foot, and lower the needle
at the starting point w. Then lower the foot.
w
c
stitch, 16 rows of darning, locking stitch again and
stop automatically.
v Turn the fabric and repeat sewing in different direction.
e
r
Sewing a shorter darning
the reverse button t.
y has been determined.
machine stops automatically.
t Reverse button
y
u
Sewing a same-sized darning
same size.
NOTE:
To reset the size of the darning, select the other stitch
pattern and reselect the darning stitch.
Adjusting the evenness of darning
Correct the evenness of the darning as follows:
"d5" is the default setting value.
When the right side of the darn is lower than the left side,
set the value to "d6" to "d9", and make the darn even.
When the left side of the darn is lower than the right side,
set the value to "d1" to "d4", and make the darn even.
q
37
Automatic buttonhole foot R
y, then press
q to
q to
Advertisement
Table of Contents
