Stopping The Engine - Echo DM-6120 Operator's Manual

Engine operation
Starting a warm engine

Stopping the engine

1. Move throttle control lever to START position 1 or 2.
2. Move choke lever (A) up to OPEN position.
3. If fuel tank is not empty, pull starter grip one to three times
and engine should fire. Do not use choke.
4. If fuel tank is empty, after refilling, push the purge bulb (C)
(until fuel is visible in clear fuel return line (D)) and then pull
the starter grip. Do not use choke.
 If engine does not start after 4 pulls, use cold starting proce-
dures.
1. Close valve (mister).
2. Then let engine run at idle for cooling down.
3. Move throttle control lever (E) down STOP position (H).
4. If engine does not stop, move the choke lever up to close po-
sition to stall Engine. The engine will stall and come to a halt
(an emergency stop).
 If the engine fails to stop, have your dealer inspect and repair
before you use the product again.
5. Always disconnect the spark plug wire from the spark plug to
ensure the engine cannot be started before you work on the
unit or leave it unattended.
12
NOTE