Rear Panel; Ac Power Inlet; External Speaker Jack; Impedance Selector - Peavey Windsor Operating Manual

Rear Panel

15

AC POWER INLET:

15
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line volt-
age is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used
does not have a ground pin, a suitable grounding adapter should be used and the third wire should be
grounded properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and
all associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-
ings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and
yellow must be connected to the terminal which is marked by the letter E, or by the Earth symbol, or
colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal
which is marked with the letter N, or the color black. (3) The wire which is colored brown must be con-
nected to the terminal which is marked with the letter L, or the color red.
To avoid the risk of electrical shock, do not place fingers or any other objects into empty tube sockets
while power is being supplied to unit.

EXTERNAL SPEAKER JACK

16
Provided for connection of external speaker cabinet(s). Load Impedance is selectable via the IMPED-
ANCE SELECTOR (17) on the Windsor.

IMPEDANCE SELECTOR

17
This three-position switch allows appropriate selection of speaker cabinet impedance. If two enclosures
of equal impedance are used, the switch should be set to half the individual value. For example,
two 16 Ω enclosures necessitate an 8 Ω setting, while two 8 Ω enclosures would require a 4 Ω setting.
Minimum speaker impedance is 4 Ω.
FOOTSWITCH JACK
18
Provided for the connection of the optional footswitch (item #00579720). The footswitch is used to
select the Effects Loop and to activate/defeat the BOOST SWITCH. LED's on the footswitch illuminate to
indicate current settings. If no switch is depressed in the Boost section, the Boost footswitch does not
function. When using the footswitch, always insert the plug fully (second click) into the FOOTSWITCH
JACK to ensure proper operation.
16
17
11
18