Care & Safeguards - A.O. Smith AO-US-200 Owner's Manual

INSTALLATION GUIDE
5
STEP 6 Check for Leaks and Proper Installation
Turn on COLD water supply. Turn on dedicated faucet
and check for leaks. Leave water running to flush
cartridge for 10 minutes or until water is clear of carbon
fines. While the system is flushing, check for leaks. Once
system is flushed, turn off dedicated faucet.
Note: Do not drink flushed water.
CARE & SAFEGUARDS
Care
To clean your filter system, wipe down the exterior with a damp cloth.
Once filters are at 95% capacity (about every 6 months), the battery alarm will
sound and flash red when water is flowing and will continue for 15 seconds
once water is turned off. Change the battery every time you replace your filters.
The battery is included with the filter replacement cartridges.
NOTICE
Safeguards
• If you experience a hose connection leak, disconnect and re-set the hose.
• Do not install this system where the line pressure may exceed 80 psi. The operating
pressure range for this system is between 20-80 psi.
• Install on COLD water lines only (40°F - 90°F).
• Use caution when installing the system manifold on a cabinet wall that backs up to a
dishwasher. Screws may exceed cabinet width.
• It is recommended that your system be installed inside and out of direct sunlight. The
system must be protected from both direct sunlight and freezing temperatures.
• System and installation shall comply with applicable state and local laws.
• Do not operate without the filters installed.
• Must replace housing every 5 years or risk property damage from leaks. Call
800.821.2017 to order.
• Do not use with water that is microbiologically unsafe or of unknown water quality
without adequate disinfection before or after the system.
• Systems certified for cyst reduction may be used on disinfected waters that may
contain filterable cysts.
NEED HELP? GIVE US A CALL 877.333.7108