Advertisement
Contents
Connections
Network
To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set "DHCP" to "On". (Use the default setting.) This allows this unit to use your home network (LAN).
When assigning an IP address to each device manually, you need to assign an IP address to this unit using the "IP Address" settings, and enter
information about your home network (LAN) such as the gateway address and subnet mask, etc.
Network Information
Displays network information.
Friendly Name / Connection / SSID (Wi-Fi Signal Strength) / DHCP /
IP Address / MAC Address (Ethernet) / MAC Address (Wi-Fi)
Network & USB-A
The network and USB flash drive playback (USB-A) functions can be
stopped to prevent noise that affects the sound quality. This enables
playback with a high sound quality when using the D/A converter
functions.
Enabled
Enables the network and USB flash drive
(Default) :
playback (USB-A) function.
Disables the network and USB flash drive
Disabled :
playback (USB-A) function.
Front panel
Rear panel
Playback
Settings
Wi-Fi
The Wi-Fi function can be stopped to prevent noise that affects the sound
quality. Using a wired LAN to connect this unit to the network enables
playback with a high sound quality.
Enabled
(Default):
Disabled:
Bluetooth
Stopping Bluetooth function reduces a source of noise that affects sound
quality, enabling higher sound quality playback.
Enabled
(Default):
Disabled:
92
Remote control
unit
Tips
Enables the Wi-Fi function.
Disables the Wi-Fi function.
Enables the Bluetooth function.
Disables the Bluetooth function.
Index
Appendix
Advertisement
