Download Print this page

Power Section; Patch Input - Peavey Nashville 400 User Manual

Peavey nashville 400: user guide

Advertisement

NASHVILLE'" 400 SPECS
POWER AMPLIFIER SECTION:
RATED POWER & LOAD:
210 W RMS into 4 ohms
with DDTgcompression
and LED indicator
POWER @ CLIPPING: (TYPICALLY)
THD, 1 KHz, 120 VAC line)
(5%
130 W RMS tino 8 ohms
220 W RMS into 4 ohms
2 ohms not recommended
FREQUENCY RESPONSE:
TOTAL HARMONIC DISTORTION:
Less than 0.2O/6, 1OOmW to 200 W RMS,
20 Hz to 10 KHz, 4 ohms, typically below 0.1%
Greater than 20 dB
Below 0.5% THD for 6 dB overload
Below 1% THD for 20 dB overload
HUM & NOISE:
Greater than 95 dB below rated power
POWER CONSUMPTION: (DOMESTIC)
600 watts, 50/60 Hz, 120 VAC
EXPOSURE TO EXTREMELY HIGH NOISE LEVELS MAY CAUSE A PERMANENT HEARING LOSS INDIVIDUALS VARY CONSIDERABLY IN SUSCEPTIBILITY TO NOISE INDUCED HEARING LOSS BUT NEARLY
EVERYONE WILL LOSE SOME HEARING IF EXPOSED TO SUFFICIENTLY INTENSE NOISE FOR A SUFFICIENT TIME
OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION iOSHAi
THIS LIMITED WARRANTY VALID ONLY WHEN PURCHASED AND REGISTERED IN THE UNITED STATES OR CANADA. ALL EXPORTED PRODUCTS ARE SUBJECT TO
WARRANTY AND SERVICES TO BE SPECIFIED AND PROVIDED BY THE AUTHORIZED DISTRIBUTOR FOR EACH COUNTRY.
Ces clauses de garantie ne sont vaiables qu'aux Etats-Unis et au Canada. Dans tous les autres pays, les clauses de garantie et de maintenance sont lixees par le distributeur national et
Diese Garantie ist nur in den USA and Kanada gultig. Alle Export-Produkte sind der Garantie und dem Service des lmporteurs des jewelligen Landes unterworfen.
Esta garantia es vallda solamente cuando el product0 es comprado en E.U. continentales o en Canada. Todos 10s productos que Sean comprados en el extranjero, estan sujetos a las
garantias y servicio que cada distribuidor autorizado determine y olrezca en 10s diferentes paises.
PEAVEY ELECTRONICS CORPORATION ("PEAVEY") warrants this product, EXCEPT for covers, footswitches, patchcords, tubes and meters, to be free from defects in maternal
and workmanshipforaperiod
of one (1) yearfromdateof purchase, PROVIDED, howeverthatthlslimlted
conditions, exclusions and IImitations hereinafter set forth:
If this product contains tubes or meters, Peavey warrants the tubes or meters contained in the product to be free from defects in material and workmanshlp for a period of nmety (90)
days from date of purchase; PROVIDED, however, that this limited warranty is extended only to the orlglnal retail purchaser and
These limIted warranties shall be void and of no effect if
a The first purchase of the product is for the purpose of resale, or
b. The original retail purchase
workmanship; or
In the event of a defect in material and/or workmanship covered by this limited warranty, Peavey
a. In the case of tubes or meters, replace the defective component without charge,
b. In other covered cases (I.e., cases Involving anything other than covers, footswitches, patchcords. tubes or meters), repair the defect in material or workmanship or replace
the product, at Peavey's option;
and provided, however, that, in any case, all costs of shlpping, if necessary, are paid by you, the purchaser.
THE WARRANTY REGISTRATION CARDSHOULD BE ACCURATELY COMPLETED AND MAILEDTOAND RECEIVED BY PEAVEY WITHIN FOURTEEN (14) DAYS FROMTHE
DATE OF YOUR PURCHASE
In order to obtain service under these warranties, you must
a. Bring the defective Item to any AUTHORIZED PEAVEY DEALER or AUTHORIZED PEAVEY SERVICE CENTER and present therewith the ORIGINAL PROOF OF
PURCHASE supplied to you by the AUTHORIZED PEAVEY DEALER in connection with your purchase from him of this product.
If the DEALER or SERVICE CENTER is unable to provide the necessary warranty service you will be directed to the nearest other PEAVEY AUTHORIZED DEALER or
AUTHORIZED PEAVEY SERVICE CENTER which can provide such service.

POWER SECTION:

THE FOLLOWING SPECS ARE MEASURED @ 1
WITH THE CONTROLS PRESET AS FOLLOWS:
PRE GAIN PULL BRIGHT OFF (IN)
POST GAIN @ 10
LOW EQ @ +6 dB
MID EQ @ -9 dB
SHIFT @ 300 Hz
HIGH EQ @ +3 dB
PRESENCE EQ @ +6 dB
REVERB @ 0
NOMINAL LEVELS ARE WITH PRE GAIN @ 5
ohms
MINIMUM LEVELS ARE WITH PRE GAIN @ 10
PREAMP HIGH GAIN INPUT: (NO PAD)
Impedance: High Z, 220K ohms
Nominal Input Level: -28 dBV, 40 mV RMS
Minimum Input Level: -46 dBV, 5 mV RMS
Maximum Input Level: +8 dBV, 2.5 V RfylS
PREAMP LOW GAIN INPUT: (-10 dB PAD)
Impedance. High Z, 44K ohms
Nominal Input Level: -18 dBV, 130 mV RMS
Minimum Input Level: -36 dBV, 16 mV RMS
Maximum Input Level: +18 dBV, 8 V RMS
PATCH OUTPUT:
Function: Low Level Pre-EQ Effects/Pedal Send
Load Impedance: 1 K ohms or greater
Nominal Output: -14 dBV, 0.2 V RMS
ONE-YEAR LIMITED WARRANTY/REMEDY
PEAVEY OO-DAY LIMITED WARRANTY ON TUBES AND METERS
CONDITIONS, EXCLUSIONS AND LIMITATIONS OF LIMITED WARRANTIES
not made from an AUTHORIZED PEAVEY DEALER, or
IS
altered, defaced or removed.
IS

PATCH INPUT:

KHz
Function: Low Level Pre-EQ Effects/Pedal Return
Designed Input Level: -14 dBV, 0.2 V RMS
(Switching jack providing patch output to patch input
connection when not used)
PREAMP OUTPUT:
Function: High Level Post EQ Signal Send
Load Impedance: 1 K ohms or greater
Nominal Output: 0 dBV, 1 V RMS
Maximum Output: +18 dBV, 8 V RMS
POWER AMP INPUT:
Function: High Level Post EQ Signal Return
Impedance: High Z, 22K ohms
Designed Input Level: 0 dBV, 1 V RMS
(Switching jack providing preamp output to power amp
input connection when not used)
SYSTEM HUM & NOISE @ NOMINAL INPUT LEVEL:
(20 Hz to 20 KHz unweighted)
75 dB below rated power
EQUALIZATION:
FOOTSWITCH:
Reverb defeat
DANGER
HAS SPECIFIED THE FOLLOWING PERMISSIBLE NOISE LEVEL EXPOSURES
warrantyisextended onlytotheorlglnal
LOW: +-15 dB @ 60 Hz, Shelving
MID: +-I5 dB (@ Shift Frequency), Peak/Notch
SHIFT: 150 Hz to 1500 Hz
HIGH: +-15 dB @ 2 KHz (Special EQ)
PRESENCE: +-15 dB @ 5 KHz, Shelving
PULL BRIGHT: +6 dB @ 2 KHz
also subject to the condltlons, exclusions and
IS

Advertisement

loading

This manual is also suitable for:

Nashville