Related Manuals for Peavey Nashville 400
Summary of Contents for Peavey Nashville 400
- Page 1 AIASHVillETM WARNING: TO PREVENT ELECTRICAL SHOCK OR FIRE HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. BEFORE USING THIS APPLIANCE, READ THE OPERATING GUIDE FOR FURTHER WARNINGS.
- Page 2 INPUTS (1) The Nashville 400 has two inputs, one featuring high gain and the other one third as much gain. The High Gain Jack is the input normally used, unless a signal from the instrument is overloading the input preamp. If your input signal is overloading (distorting) the High Gain Jack, then the Low Gain Jack (-10 dB) should be used.
- Page 3 3 dB of boost doubles the amount of power necessary to produce the desired amount of low end. Even the 200 watt RMS capability of the Nashville 400 may be overloaded by excessive low end boost at high volume levels.
- Page 4 PREAMP OUT AND POWER AMP IN (15) To allow “in line” patching of various accessories we have included a system of preamp out/power amp in jacks on the rear panel. The Preamp Out is a straight preamp signal which includes the entire equalization circuit plus reverb. The output level is approximately 1 volt RMS and is relatively low, 600 ohms impedance.
- Page 5 IImitations hereinafter set forth: If this product contains tubes or meters, Peavey warrants the tubes or meters contained in the product to be free from defects in material and workmanshlp for a period of nmety (90) days from date of purchase; PROVIDED, however, that this limited warranty is extended only to the orlglnal retail purchaser and IImItations hereinafter set forth.
- Page 6 CARD will help ensure that you are contacted and properly notified. b. Notice of address changes - If you move from the address shown on the WARRANTY REGISTRATION CARD, you should notify Peavey of the change of address so as to...