Table of Contents
Advertisement
Building Technologies
6.2.3 Motor Nameplate Data
Setup menu
The setup menu is a fixed sequence of screens that allow the user to perform the basic commissioning of the
Inverter.
Once a parameter value has been modified, there is no possibility to cancel the basic commissioning
process. In this case, the basic commissioning process must be completed. If no parameter value has been
modified, then a short press of
will return to the previous screen and a long press (more than 3 seconds)
of
will return to the top of the Monitor menu.
When a parameter value has been modified and the new value confirmed by pressing
, then the next
parameter in the basic commissioning sequence is automatically displayed.
Editing parameters
Parameters can be modified use two methods; scrolling through the parameter values or using the single
digit methods. Both these methods are described in section 7 of this manual.
Basic commissioning
Note: Maximum motor RPM (Parameter P1082)
The maximum motor RPM will not be required to be entered by the user during the basic commissioning
process. The maximum motor RPM is automatically calculated during the motor calculation phase of basic
commissioning. Should the user wish to view or edit parameter P1082, it is still available through the
"Parameter" menu.
The basic commissioning process will require the input of data which is specific to the motor to which the
Inverter is connected. The data regarding the attached motor can be gathered from the motor's rating plate.
An example of a typical motor rating plate is shown in the figure below:
Page 21 of 50
Last Revised: 4/11/2011
Advertisement
Table of Contents
