Table of Contents
Advertisement
S A F E T Y P R E C A U T I O N S
• DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow ap-
proximately 15 minutes for the fixture to cool down before servicing.
• DO NOT shake fixture, and avoid using brute force when installing and/or operating the
fixture.
• DO NOT operate the fixture if the power cord is frayed, crimped, damaged, and/or if any
of the power cord connectors are damaged and do not plug into the fixture securely with
ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its con-
nectors are damaged, replace it immediately with a new one of the same power rating.
• DO NOT block any air ventilation slots.
• All fan and air inlets must remain clean and never blocked.
• Leave approx. 6" (15cm) between the fixture and other devices or a wall in order to allow
for proper cooling.
• When installing in a suspended environment, always use mounting hardware that is no less
than M10x25mm, and always install fixture with an appropriately rated safety cable.
• Always disconnect the fixture from the main power source before performing any type of
service and/or cleaning procedure.
• Only handle the power cord by the plug end. Never pull out the plug by tugging on the wire
portion of the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the inte-
rior of the fixture. This is a normal process and is caused by excess paint in the interior of
the casing burning off from the heat associated with the lamp. This will decrease gradually
over time.
• Consistent operational breaks will ensure fixture will function properly for many years.
7
Advertisement
Table of Contents
