Table of Contents
Advertisement
E - F LY W I R E L E S S D M X S E T U P
BEFORE SETTING THE WIRELESS CHANNEL ON ANY E-FLY FIXTURE, MAKE SURE
THE SOURCE WIRELESS DMX TRANSCEIVER DEVICE IS OFF.
TO CONTROL FIXTURE WITH E-FLY WIRELESS DMX SIGNAL, FOLLOW THE STEPS BELOW:
1. Ensure the source E-FLY wireless DMX Transceiver device is powered OFF.
2. Power ON fixture and use the LCD control panel to select DMX & E-FLY or E-FLY & OUT in
the Select Signal sub menu of the PERSONALITY main system menu.
3. From the LCD control panel, navigate to PERSONALITY > SET E-FLY CHN. Set the E-FLY
wireless channel to the same wireless channel as the source E-FLY DMX Transceiver device.
NOTE: Erratic fixture movement may occur if other E-FLY wireless DMX products are
in use in the same area and are using the same E-FLY wireless channel. The fixture may
immediately start to respond to the DMX wireless signal from another E-FLY wireless
DMX Transceiver when E-FLY is enabled. Make sure to confirm if any E-FLY wireless
channels are being used in the area where the fixture is being installed. ELATION E-FLY
WIRELESS TRANSCEIVER only has 0-14 wireless channels, NO CH 15.
4. Navigate to FUNCTION > SET DMX ADDRESS in the system menu, and select the desired
DMX address for this fixture.
5. The E-FLY signal Indicator on the fixture LCD control display will illuminate GREEN if a suc-
cessful wireless DMX connection has been made, or illuminate RED for NO connection. If no
connection is made, repeat steps 1-4 above.
6. Repeat this process for all E-FLY compatible fixtures in the E-FLY wireless network, mak-
ing sure all fixtures are assigned the same E-FLY wireless channel.
7. After all fixtures in the E-FLY wireless network have been set to the same E-FLY wireless
channel and powered ON, switch ON power to the source E-FLY DMX Transceiver device.
8. Test all fixtures connected to the E-FLY wireless network to confirm proper functionality.
14
Advertisement
Table of Contents
