Front Panel; Phones] Knob - Roland VR-6HD Startup Manual

Panel Descriptions
22
VIDEO SWITCHER [1]–[6] buttons
The buttons change functions depending on the mode that's
selected.
23
[CUT] button, [AUTO] button
These buttons determine what happens when switching between
videos or else they switch between videos, depending on the
operation mode.
There are two operation modes for switching between videos:
"DISSOLVE" and "PGM/PST".
Operation
Explanation
mode
This mode selects the video to output and immediately
outputs it to the PGM bus.
Press the [CUT] or [AUTO] button to select what happens
when you switch between videos (the buttons light up green
when pressed).
Button to operate
DISSOLVE
(factory
setting)
VIDEO SWITCHER
[1]–[6] buttons
* The PGM source and PST source buttons blink red during
the transition effect.
In this mode, the PST video is displayed in the PVW bus, and
you can check the video before outputting it to the PGM bus.
Press the VIDEO SWITCHER [1]–[6] buttons to select a PST
video (the buttons light up green). The content is shown in
the PVW bus.
Button to operate
[CUT] button
PGM/PST
(lights up red)
[AUTO] button
(lights up red)
* During the transition effect, the selected VIDEO SWITCHER
button blinks red, and then remains lit up red when the
transition effect finishes.

Front Panel

1
PHONES jack
Connect your headphones here.
2

[PHONES] knob

Adjusts the headphone volume.
4
Action taken when pressed
When [CUT] button is lit up green
The video switches instantly.
When [AUTO] button is lit up green
A switch (transition) effect is
applied, and the video switches
automatically.
Action taken when pressed
The video switches instantly.
A switch (transition) effect is
applied, and the video switches
automatically.
1 2 3 4
3
USB HOST connector
Connect USB storage such as a USB flash drive or an external SSD
here, for backing up this unit's settings or importing materials
from the storage device into this unit.
4
SDXC card slot
Insert an SD card here.