Battery Cabinet Storage; Preliminary Operations; Battery Cabinet Handling - Riello K160240PB12T User Manual

BATTERY CABINET STORAGE

The storage site must comply with instructions contained in the "Technical features" chapter.
The batteries contained in the cabinet are subject to self-discharge. Whenever the battery cabinet is stored
and not installed immediately, take note of the date printed on the packing plate of the battery charger and
recharge by that date.
To recharge batteries, simply plug the battery cabinet in to a NORMAL OPERATION UPS for at least 24
hours.
For longer storage periods, contact technical assistance.

PRELIMINARY OPERATIONS

CHECKING PACKAGING AND REMOVAL

Upon receipt of the battery cabinet, ensure that packaging has not been damaged during transport. In
particular, check that none of the two anti-shock devices set in the packaging have become red. If any
are red, follow instructions contained on the packaging.

The battery cabinet should be handled with care. Any shocks or falls can cause damage.

Remove packaging carefully to avoid scratching equipment.
Operate as follows to remove packaging:
o
Cut straps
o
Carefully remove from the cardboard packaging
o
Unscrew the stops before removing the cabinet from the pallet

The battery cabinet, complete with assembled batteries, comes supplied with: warranty, user's manual,
2x 125A gS NH00 or 2x 63A gS NH000 fuses (20 batteries version); 3x 125A gS NH00 or 3x 63A gS
NH000 fuses (40 batteries version), fuse extraction handle.

Included in supply of the empty battery cabinet: warranty, user's manual, numbered cables (internal
wiring), fuses, fuse extraction handle, battery assembly accessory.

BATTERY CABINET HANDLING

Two cases are possible regarding cabinet handling:
1) Empty battery cabinet
2) Battery cabinet with pre-mounted internal batteries. In this case, the battery cabinet must be
handled with all its panels (side, front, rear and internal) fully tightened.
Handling (both before and after removing from packaging) must be performed with a fork lift equipped as
shown in Fig. 1.
HANDLING WITH PACKAGING
Procedure to follow to move the still packaged
BATTERY BOX
- ENGLISH -
REMOVING FROM PALLET
Procedure to follow to remove from the pallet after
having removed packaging
Fig. 1
6