Selecting A Location; Adjusting The Leveling Feet; Removing The Shipping Bolts - Samsung WF-J1461V User Manual

installing the washing machine

SELECTING A LOCATION

Before you install the washing machine, select a location with the following characteristics:
• A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet," below)
•
Away from direct sunlight.
•
Adequate ventilation
•
Room temperature that will not fall below 0˚C
• Away from sources of heat such as coal or gas Make sure that the washing machine does
not stand on its power cord. Ventilation openings must not be obstructed by carpeting when
the washing machine is installed on a carpeted floor.

ADJUSTING THE LEVELING FEET

If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the
feet):
1. Loosen the leg bolt by turning it with your hand
until it is at the desired height.
2. Tighten the locking nut by turning it with the
wrench.
• Place the washer on a sturdy, flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration occurs.
(Only a 1 degrees angle is allowed.)

REMOVING THE SHIPPING BOLTS

Before using the washing machine, you must remove all of the shipping bolts from the back of
the unit.
To remove the bolts:
1. Loosen all bolts with the wrench before removing
them.
2. Take each bolt head and pull it through the wide
part of the hole. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts for future use.
6_ Installing the washing machine
WF-J1461-02456G_EN.indd 6
Cotton
Remaining Time Synthetic
Pre-wash
Delicate
12:00 o C Wash
rpm Wool
Min Rinse Power
START
Speedy
Spin PAUSE
Check Delay Start
Eco
Fuzzy control
Door open
Temp Spin Delay Start Function
2007-05-21 ø¿»ƒ 6:59:55