Panasonic AW-EX500N Operating Instructions Manual page 11

=Function setting switch 2
This is used to select the operations of the AW-EX500.
Before changing a setting, the power must be turned off.
The setting items are shown below.
ON
4
——
3
2
N SYNC ON
O 1
RGB
YC
1: Output signal setting 1 [D-SUB OUT SEL1]
<YC/RGB, YR-YB-Y>
2: Output signal setting 2 [D-SUB OUT SEL2]
<RGB/YR-YB-Y>
These are used to select the signals to be output to pins
#3, #4 and #5 of analog video output connector 1.
The switch combinations are shown below.
D-SUB OUT SEL1 D-SUB OUT SEL2
RGB, YR-YB-Y
RGB, YR-YB-Y
Y/C
Y/C
OFF SW NO
—— NOT USE
SYNC OFF RGB OUT SYNC
YR-YB-Y D-SUB OUT SEL 2
RGB, YR-YB-Y D-SUB OUT SEL 1
(Factory setting: RGB, YR-YB-Y)
(Factory setting: YR-YB-Y)
Output signal
YR-YB-Y Component
RGB RGB
YR-YB-Y Y/C
RGB Y/C
3: Analog RGB output SYNC addition setting
<SYNC ON/SYNC OFF>
This is used to set whether to add the SYNC signal to
the RGB signals when RGB has been selected as the
analog video output setting.
4
At SYNC ON, the SYNC signal is added to the R, G
3
2
and B signals.
1
4: Not used <ON/OFF>
Keep this at the factory setting.
> Additional card slot
Remove the cover, and connect the AW-EX100 additional
card box.
- 11 -
(Factory setting: SYNC OFF)
(Factory setting: OFF)