Panasonic AW-EX500N Operating Instructions Manual page 10

Major operating controls and their functions
6: RS232C select <ADDITIONAL IF/OPTION IF>
This setting is used to select either the optional card slot
or additional card slot as the destination for the
connection of the RS-232C connector 2 on the rear
panel of the signal converter. At the <OPTION IF>
setting, the connector is connected to the optional card
which has been plugged into the optional card slot.
7: Optional card slot AW-PB302 output setting
<YR-YB-Y/RGB>
This setting is used to select the signal to be output
from the connector on the AW-PB302 (RGB card)
when the AW-PB302 has been plugged into the
optional card slot.
The setting has no effect when a card other than the
AW-PB302 has been plugged into the slot.
8: Additional card slot AW-PB302 output setting
<YR-YB-Y/RGB>
This setting is used to select the signal to be output
from the connector on the AW-PB302 (RGB card)
when the AW-PB302 has been plugged into the
additional card slot using the AW-EX100.
The setting has no effect when a card other than the
AW-PB302 has been plugged into the slot.
(Factory setting: OPTION IF)
(Factory setting: RGB)
(Factory setting: RGB)
9: Optional card slot optional card setting
<PB302/PB310>
Set this to <PB302> for use when the AW-PB302 card
is to be plugged into the optional card slot;
alternatively, set it to <PB310> for use when the
AW-PB310 is to plugged in.
The setting has no effect when a card other than the
AW-PB302 or AW-PB310 has been plugged into the
slot.
0: Additional card slot optional card setting
<PB302/PB310>
Set this to <PB302> for use when using the
AW-EX100 to plug the AW-PB302 card into the
additional card slot; alternatively, set it to <PB310> for
use when the AW-PB310 is to plugged in.
The setting has no effect when a card other than the
AW-PB302 or AW-PB310 has been plugged into the
slot.
- 10 -
(Factory setting: PB310)
(Factory setting: PB310)