Table of Contents
Advertisement
Error Items
When the AUTO OFF lamp is lighted
Monitor display
S-FF/REW TIMEOVER
S REEL TOO FAST
S REEL TORQUE ERR
T REEL TOO FAST
T REEL TORQUE ERR
UNLOAD ERROR
WINDUP ERROR
W-UP REEL NOT ROTA
Description
If the start/end processing operation is not completed, the
AUTO OFF lamp lights, and the message display flashes.
If the supply reel motor should rotate at an abnormally fast
rate, the AUTO OFF lamp lights, and the message display
flashes.
If an abnormal torque applied to the supply reel motor is
detected or if an abnormal current flowing to the current-
sensing resistor is detected, the AUTO OFF lamp lights,
and the message display flashes.
If the take-up reel motor should rotate at an abnormally
fast rate, the AUTO OFF lamp lights, and the message
display flashes.
If an abnormal torque applied to the take-up reel motor is
detected, the AUTO OFF lamp lights, and the message
display flashes.
If the tape has not been wound up during unloading, the
AUTO OFF lamp lights, and the message display flashes.
If, after the total tape amount has been detected, the
amount of tape wound up on the take-up reel and the
amount of tape supplied by the supply reel differ to an
abnormal extent while the tape is traveling in the forward
or reverse direction, the AUTO OFF lamp lights, and the
message display flashes.
If, after the cassette has been inserted, the tape take-up
reel has not wound up the tape while the total tape amount
is not detected and while the tape is traveling in the
forward or reverse direction, the AUTO OFF lamp lights,
and the message display flashes.
– 32 –
VTR operation
STOP
(POWER OFF 5 ON)
STOP
(POWER OFF 5 ON)
STOP
(POWER OFF 5 ON)
STOP
(POWER OFF 5 ON)
STOP
(POWER OFF 5 ON)
STOP
(POWER OFF 5 ON)
STOP
(POWER OFF 5 ON)
STOP
(POWER OFF 5 ON)
Advertisement
Table of Contents
