Table of Contents
Advertisement
Troubleshooting
Other symptoms
Symptom
$ The playback images of the tape
inserted into the internal VTR are
not shown on the video monitor
(used to check the images) even
when the on-screen PLAY button is
clicked.
$ Disk images cannot be uploaded.
$ Noise is superimposed onto the
disk images or some frames are
missing.
$ The preview images of the internal
VTR break up frequently.
Suggested remedial action
O Has the power of the monitor (Video) for monitoring the pictures
been turned on?
O Has the monitor (Video) for monitoring the pictures cable been
connected properly?
O Has the VTR tape been loaded?
O Have images been recorded properly on the VTR tape?
O Has "50Mx2, 50Mx1, 25Mx4" been selected for the device setting?
O Do the tape format and device format match?
O Is there enough free memory on the AV disk?
The free memory left on the AV disk can be checked using the "Free"
display in the "Digitizer" editing program.
When the display reads "00:00:00:00," it means that there is no free
memory left. The clips which are no longer required must be deleted
to free up the amount of memory needed.
O Has a program other than the designated editing application program
been installed?
The product may fail to operate properly if a program other than the
designated editing application program has been installed.
O Is a program or programs other than the designated editing
application program being run?
O Has the reference input been turned on or off?
O In the case of uploaded data, is there a problem with the tape which
was used for uploading? Alternatively, does the VTR which was
used for recording have dirty heads?
O Is there a problem with the tape which was used?
O Does the VTR have dirty heads?
The preview images of the internal VTR are not played back in the
complete on-track status. Some playback images may be disrupted.
– 26 –
Advertisement
Table of Contents
