6
From the File menu, select New –
Project.
7
As shown in the right figure, after you
select Power PMAC, input a project
name and save destination, and select
the OK button.
3-2-2
Controller Initial Setting
Follow the procedure below to perform the initial settings for the Controller.
Precautions for Correct Use
Since all memory is cleared by the initial settings, be sure to save any data remaining in the
Controller that you may need.
1
Type the $$$*** command from the Ter-
minal, and set the Controller to the fac-
tory default state.
Application Guide Laser Application (O052)
3 Connection Procedures
3
3-5