Table of Contents
Advertisement
Setup : Satellite Setup – Dish position
This screen allows you to position your Satellite antenna by having the Digital Satellite
Receiver provide approximate values for elevation, azimuth and tilt (marked in degrees),
after the you have entered your 5-digit zip code.
Procedure
r
In Sat Setup menu, press
displayed.
u
r
Press
button to enter your Zip code. Use the numeric keys on the Remote Control to input
your zip code numbers. Press
r
Press ACTION button to enter the new zip code. Elevation, Azimuth and Tilt are automatically
displayed after you press the ACTION button.
r
This information should be used to properly align and position the satellite antenna. These
values are approximations. Proper alignment should also be verified by using the signal strength
meter.
Setup : Satellite Setup – Signal Meter
Since the Digital Satellite Receiver is capable of receiving satellite programming from
multiple DIRECTV satellites, the user has the ability to choose one of 3 supported
satellites to receive signal strength and is primarily used during the system set-up
procedure. The Digital Satellite Receiver signal meter uses a horizontal digital signal
strength percent bar meter. The user will have the ability to select which transponder (1 to
32) they wish to measure the signal strength. The following is the signal meter screen
Procedure
r
In the Sat. Setup menu, press
u
r
Press
to highlight Satellite.
u
r
Press
to change Satellite
pq
r
Press
buttons to select Satellite A, B or C.
r
Press ACTION to enter the selection.
q
r
Press
button to highlight Transponder.
u
r
Press
button then
that gives you a signal strength of 85%.
t
r
Press
two times to return to SETUP menu.
q
Zip code for position
Sat Setup
Elevation
Sat Ports
Azimuth
Tilt
Dish Pos
Sig Meter
Enter zip code, press ACTION
u
Press
to change the zip code.
Dish position screen
pq
buttons to highlight Dish Position. Dish Position sub menu is
u
button to move to the next position.
q
Satellite
Sat Setup
Transponder
Sat Ports
Dish Pos
Sig Meter
u
Press
to change satellite.
Signal Meter Screen
q
button to highlight Signal Meter. Sub- menu is displayed.
pq
buttons to choose one of 32 transponders. Select the transponder
R
G
M
OLLER
UIDE
ENU
92154
51 degrees
166 degrees
101 degrees
u
A
1 of 32
Signal strength 91%
O
PERATIONS
.
39
Advertisement
Table of Contents
