Atf Circuit; Atf Pipes, Atf Cooler And Atf Pre-Heater - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
9

ATF Circuit

⇒ "9.1 ATF Pipes, ATF Cooler and ATF Pre-Heater", page 94
⇒ "9.2 ATF Preheater, Removing and Installing", page 99
⇒ "9.3 ATF Pipes and ATF Cooler, Removing and Installing", page
102
⇒ "9.4 ATF Pipes for ATF Cooler with Clamping Connections",
page 105
⇒ "9.5 ATF Pipes and ATF Cooler, Cleaning", page 107
9.1 ATF Pipes, ATF Cooler and ATF Pre-
Heater
⇒ "9.1.1 Overview - ATF Line and ATF Cooler, Vehicles with 6-
Cylinder, 3.0L TFSI and 8-Cylinder, 4.2L TDI Engines",
page 95
⇒ "9.1.2 Overview - ATF Lines, ATF Cooler and ATF Pre-Heater,
Vehicles with 6-Cylinder 3.0L TDI Engine", page 97
Caution
ATF pipe leaks
♦ To avoid contact between ATF pipes and the sealing sec‐
tion, clip the sealing section approximately 5 mm as
shown.
♦ Remove debris in this area.
♦ Refer to the Technical Service Bulletin for this procedure.
Note
Pronged ring on the ATF pipe.
♦
The upper ATF pipe -3- has a pronged ring -1- to protect it from
♦
touching the longitudinal member -4-.
If the pronged ring is not there and the ATF pipe is damaged,
♦
then the ATF pipe must be replaced.
A missing pronged ring must be exchanged.
♦
94
Rep. Gr.37 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.