Alfa Romeo Tonale Quick Manual page 35

Also in this case, if the pressure is lower
than 2 bar/ 29 psi after 10 minutes
from the compressor switching on, do
not resume driving but contact an Alfa
Romeo Dealership.
53
After driving about 8 km / 5 miles, park
the car in a safe and convenient area,
stop the engine, turn on the hazard
warning lights, apply the parking brake;
move the gear lever to P and leave the
wheels steered. In the event of a steep
slope, place a wedge or stone behind
the wheels.
34
Take the compressor and restore the
pressure using the black inflation tube.
If the pressure shown is higher than
2 bar / 29 psi, restore the pressure
and drive safely to an Alfa Romeo
Dealership as soon as possible. If the
pressure is lower than 2 bar / 29 psi, do
not resume driving but contact an Alfa
Romeo Dealership.
Overpressure valve
9650410
54
If the tyre pressure turns out to be
higher than expected, it is possible,
after turning off the compressor, to
lower it using the button fig. 54 placed
near the black hose fixing connector.
WARNING
49) WARNING: Do not exceed 80 km/h.
Avoid sudden acceleration or braking. The
Fix&Go kit provides a temporary repair,
therefore the tyre must be examined
and repaired by a specialist as soon as
possible. Before using the Fix&Go kit,
ensure that the tyre is not damaged
excessively and that the rim is in good
condition, otherwise do not use it and
call roadside assistance. Do not remove
foreign bodies from the tyre.
50) Punctures on the sides of the tyre may
not be repaired. Do not attempt to use the
Fix&Go kit if the tyre was damaged as a
result of being used when underinflated.
51) Wear the protective gloves provided
with the Fix&Go kit.
52) Apply the adhesive label where it can
be easily seen by the driver as a reminder
9650411
that the tyre has been treated with the
Fix&Go kit. Drive carefully, particularly
on bends. Do not exceed 80 km/h. Avoid
sudden acceleration or braking.
53) Repairs are not possible in the case
of damage to the wheel rim (bad groove
distortion causing air loss). Do not remove
the foreign body (screws or nails) from the
tyre.