Charging Port On The Car; Types Of Charging Cables - Alfa Romeo Tonale Quick Manual

CHARGING PORT ON THE CAR

25
To access the charging port, open the
charging flap (1) fig. 25 on the left side
by pressing the area indicated by the
arrow.
WARNING The courtesy lights on the
charging port flap remain on for a few
seconds and turn off while charging.
Charging port LED
Next to the charging port there are
some LEDs (1) fig. 26, which indicate
the charging status by means of four
different colours and related flashing
types:
Blue: to indicate that the system is
waiting for a charging schedule.
Green flashing: during the charging
process.
Steady green: to indicate that the
charging process is complete.
20
Red flashing: : to indicate a fault in the
charging system or when there is a fault
in the charging procedure (e.g. when
the charging connector is connected
to the charging port located on the car
and the cable has not been previously
connected to the power socket).
9650199
26
WARNING Use only the charging cable
supplied with your car or a replacement
cable recommended by FCA. Refer
to the label on the control unit, which
indicates the "Country Group" (1) fig. 27
and the electrical current level (Amps)
(2), and the "Mode 2 Cable Variants"
table in the "Power sources that can be
used" chapter of the Owner Handbook.
27

TYPES OF CHARGING CABLES

Two different types of cables can be
used for charging:
"Mode 2" (A) charging cable fig. 28 (for
versions/markets where provided):
this allows charging from an earthed
9650201
domestic power socket. This type
of socket is used for charging with
alternating current. The "Mode 2"
charging cable complies with IEC
61851, IEC 62752 and SAE J1772
standards.
"Mode 3" (B) charging cable fig. 29 (for
versions/markets where provided): this
allows charging from a public charging
station and a domestic AC (alternating
current) charging station (wallbox).
The charging speed may be faster than
charging through a domestic power
socket.
9650202