Table of Contents
Advertisement
Programming
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
M
N
2
MbN: "Base Unit Setup" a M
3
MbN: "Repeater Mode" a M
4
MbN: Select the desired setting. a
M
N a M
Note:
R After turning the repeater mode on or off,
may flash on the handset momentarily.
This is normal and the handset can be used
once
stops flashing.
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Proceed with the operation for your
model.
n KX-TG2711 series: page 3
Press and hold M
seconds. (No registration tone)
n KX-TG2721 series: page 3
Press and hold M
seconds, until the registration tone
sounds.
20
TG2711_21BX_UE(en)_0906_ver001.p20
2
3
N
N
N
N for about 5
N for about 5
20
R The next step must be completed
within 90 seconds.
DECT repeater:
Connect the AC adaptor, then wait until
the
indicator and
indicator light
green.
Base unit:
To exit the registration mode, press M
R The registration tone stops.
(KX-TG2721 series: page 3)
2012/09/06
18:55:17
N.
Advertisement
Table of Contents
