Table of Contents
Advertisement
COMPU LINK Remote Control System
The COMPU LINK remote control system allows you to operate
JVC audio components through the remote sensor on the center unit.
To use this remote control system, you need to connect JVC audio
components through the COMPU LINK-3 (SYNCHRO) jacks (see
below) in addition to the connections using cables with RCA pin
plugs (see pages 8 and 9).
• Make sure that the AC power cords of these components are
unplugged before connection. Plug the AC power cords only after
all connections are complete.
Notes:
• If your audio component has two COMPU LINK-3 (SYNCHRO)
jacks, you can use either one.
• To operate the cassette deck or MD recorder using the COMPU
LINK remote control system, set the source name correctly.(see
page 17).
• Refer also to the manuals supplied with your audio components.
This remote control system allows you to use three functions
listed right.
• Synchro recording for the casette deck or MD recorder using the
COMPU LINK remote control system is not compatible with the
center unit.
54
Cassette deck
or
MD recorder
Remote Control through the Remote Sensor on the
center unit —————————————————
You can control the connected audio components through the remote
sensor on the center unit using this remote control. Aim the remote
control directly at the remote sensor on the center unit. For details,
see page 10.
Automatic Source Selection ——————————
When you press the play (3) button on a connected component or
on its own remote control, the center unit automatically turns on and
changes the source to the component. On the other hand, if you
select a new source on the center unit or on the remote control, the
selected component begins playing immediately.
In both cases, the previously selected source continues playing
without sound for a few seconds.
Automatic Power On/Off (Standby): only possible with
the COMPU LINK-3 connection —————————
Cassette deck (or MD recorder) turns on and off (standby) along with
the center unit.
When you turn on the center unit, the cassette deck (or MD recorder)
will turn on automatically, depending on which component has been
previously selected.
When you turn off the center unit, the cassette deck (or MD recorder)
will turn off (standby).
Advertisement
Table of Contents
