Samsung MCU-S6NEK2N Installation Manual page 27

Process
– Setting for MWR-WG0**
4. MCU
1) Press the
address and
password(0202) and press the OK button.
port setting
for indoor 2) Assign an indoor unit MCU port address with [Major] General [Step1] Indoor unit/
unit Ventilator option [Step2] MCU port [Step3] MCU address & MCU port.
(for wired
For more information, please refer to the installation manual of MWR-WG0**
remote
controller)
3. Setting by using S-NET Pro 2
Set the pipe addresses by using Add-on > Change address on S-NET Pro 2. (For more information, see
the S-NET Pro 2 Help.)
and buttons at the same time for more than 3 seconds. Then you can enter the
Major Step1
Indoor unit/
General
Ventilator option
Service mode
0
Please enter your PASSWORD
Step2 Step3
MCU address
MCU port
MCU port
Description
00 to 15
A to F
27