Virtual Rear Surround; Multi Rear Surround; Seat Position; Adjusting The Bass - Panasonic SC-HT1000 Operating Instructions Manual

Virtual Rear Surround

This mode is useful if you have to place your
surround speakers near the front speakers due
to the layout of your room.
This mode makes it seem like the sound from
the surround speakers is coming from behind
you.
Press and hold [SHIFT]r[MULTI REAR] for
more than 5 seconds.
Each time you do this:
!)
V.R.S ON V.R.S OFF

Multi Rear Surround

This mode makes it seem like sound is coming
from multiple rear surround speakers virtually
when connected with surround speakers.
Press [SHIFT]r[MULTI REAR].
Each time you do this:
!)
M.R.S ON M.R.S OFF

Seat position

Using this function makes you feel like you are
sitting in the ideal seating position (in the center of
the circle formed by the speakers), even if you
cannot due to the layout of your room.
1
Press
[SHIFT]r[S.POSITION].
2
While "SEAT POSITION" is displayed
Press [3, 4, 2, 1] to select a
position.
To cancel
Press [SHIFT]r[S.POSITION] again.
[Note]
While virtual rear surround is on, the seat position is changed in
three horizontal steps.

Adjusting the bass

Press [S W.LEVEL].
Virtual speakers
Each time you press the button:
SUB W 1>SUB W 2>SUB W 3>SUB W 4 (factory preset)
^-------------------------------------------------------------}
V.REAR

Speaker level adjustments

Adjust the level of the speakers so they are the same apparent level
as the front speakers where you would normally be sitting and
listening. (L, R ➡ below, Balance)
Preparation
≥Dolby Digital and DTS: Turn off the other sound field systems.
≥Dolby Pro Logic II: Press [SHIFT]i[ÎPRO LOGIC II].
1 Press [SHIFT]r[TEST] to output a test signal.
Lch: Front left
Cch: Center
Rch: Front right
Virtual speakers
RSch: Right surround
LSch: Left surround
M.V.REAR
2 Press [VOLUME r] or [s] to set the volume level normally
used for listening.
3 Press [3] (to increase) or [4] (to decrease).
L, R: (➡below, Balance)
C, RS, LS:
To stop the test signal, press [SHIFT]i[TEST] again.
∫ To adjust speaker level during play
1 Press [SHIFT]r[CH SELECT] to select the speaker.
L R>Cch>RSch>LSch>SWch
^---------------------------------------------------}
SW: Subwoofer
≥You can only adjust SW if there is output from the subwoofer
channel.
2 Press [3] (to increase) or [4] (to decrease).
L, R: (➡below, Balance)
C, RS, LS:
SW:
Balance
You can adjust the balance of the front speakers.
1 Press [SHIFT]r[CH SELECT] to select "L R".
2 Press [2, 1] to adjust the "L", "R" balance.
j6 dB to i6 dB
j6 dB to i6 dB
j6 dB to i6 dB
RQT7061
37