Function Menu Setup; How To Use Function Menu; Frequency Step Setup; Receiving Dtmf, Dtmf Ani, 2Tone Or 5Tone Signaling - Alinco DR-CS25 Instruction Manual

How to use FUNCTION MENU

1. Press and hold key for over 2 seconds to enter the FUNCTION
FUNC
MENU SETUP.
2.
Press or to select the desired menu.
P3 P4
and key to backward menus.
P4
3.
Press / to select the desired parameter.
4.
Press any key except ,
P3
PWR
Menu No. LCD Display Å
01 STP (Channel Step)
02 T (DTMF,2 TONE, 5 TONE Of RX)
03 2TONE (TX)
04 5TONE (TX)
05 DTMF (TX)
06 SPK (Signal Combination)
07 POWER
08 BAND
09 TX
10 LOCK(Busy Channel Lock Out)
11 Editting Channel Name
12 REV (Reverse TX/RX)
13 TALK (Talk Around)
14 D (DTMF Self ID Enquiry)
15 F (5 TONE Self ID Enquiry)
16 BEEP (Beep Sound)
17 TOT (Time Out Timer)
18 APO (Auto Power Off)
19 SPD (DTMF Transmitting Time)
20 COL (Display Color)
21 SCAN
22 TB (Tone-Bust Tones)
23 DSP (Display Mode Setup)
24 CODE
25 BOOK (Address List)
26 RESTORE
Some of features can be also operated through the microphone keys.
It is recommended to read Chapter 8 (p.23) together with this chapter.
key to forward
P3
, , , key to exit.
P4
Default
5K
OFF
00
00
01
SQ
HIGH
20K
ON
OFF
-
OFF
OFF
001
12345
ON
3 Minutes
OFF
50
ORG
T0
1750
FR
OFF
-
-

FUNCTION MENU SETUP

Frequency Step Setup

Only in VFO mode, this function is valid.
1.
Press and hold key for over 2
FUNC
seconds to enter setting menu.
2.
Press / key to choose No.01 menu, LCD displays "STP--
P3 P4
125".
3.
Press / to select the desired frequency channel step.
Available steps in KHz are: 2.5(shown as 2K5), 5, 6.25(62), 8.33(83),
10, 12.5(125), 20, 25, 30 and 50.
4.
Press any key except
PWR
01 STP menu won't appear when the radio is in memory mode.

RECEIVING DTMF, DTMF ANI, 2TONE OR 5TONE SIGNALING

DTMF/5Tone/2Tone signalling are used for selective-calling. DTMF and
5Tone signalling can be applied for other advanced features such as
ANI, PTT ID, group call, remotely stun, remotely kill, revive,...etc.
Tone code settings should be performed in advance to Signaling
operations by PC programming. Manual code setting is not available.
1. Press and hold key for over 2 seconds to enter into setting
FUNC
menu.
2.
Press / to choose No. 2 menu, LCD displays "T-OFF" .
P3 P4
3.
Press / to select the desired setup.
"DTMF": The channel will be mute by a DTMF signal. The speaker
won't sound until receiving a correspondent DTMF signal. Hold
[PTT] then press [UP] directly to
transmit the pre-stored DTMF tones.
, , , , key to exit.
P3 P4
7
15