Mass Notification Features - Honeywell Notifier NFS2-3030 FACP Programming And Operations Manual

Mass Notification Features

Notes:
• MN System works on Standard and Hi-speed Noti•Fire•Net
• A total of 15 ONYXWorks workstations may participate in paging on a mass notification system.
1.2 Mass Notification Features
• MN events can be programmed as higher or lower than fire events, based on risk analysis.
• MN alarms suppress fire alarm events when MN is the highest priority.
• MN alarms are generated locally
– by an ACU, LOC, or CCS page.
– by manual activation of a UL-approved switch or button device installed for initiating MN alarms. A Listed UL2017 initiating
switch/device is required.
• MN events generate messages over Noti•Fire•Net to MN-mapped nodes.
• Programmable using VeriFire Tools.
• Automatic activation of Special Function Zone ZF20 to signal MN alarm.
Mass Notification — P/N LS10063-000NF-E:E 06/26/2019
ACU
NFS-320/SYS
(NFS2-3030 and
DVC)
NFS2-640
CCS
(NCA-2 and DVC,
NCA-2
or ONYXWorks)
Figure 1.1 Block Diagram Example of an MN System
LOC LOC
(DVC-RPU and (DVC-RPU and
LCD-160) LCD-160)
Noti•Fire•Net
LOC
(DVC-RPU and
ACU
LCD-160)
(NCA-2 and
DVC)
LOC
(DVC-RPU and
LCD-160)
LOC
LOC
(DVC-RPU and
(NCA-2 or NFS2-
LCD-160)
3030 and DVC)
Introduction
7