Advertisement
BLIZZARD
WARNING
To prevent accidental plow activation, turn
POWER switch to the "OFF" position when
not in use.
12 Assem. Instructions - Testing The Snowplow
Testing The Snowplow
1.
Fill the HYDRAULIC PUMP FLUID RESERVOIR with BLIZZARD SNOW-
PLOW RAPID ACTION HYDRAULIC OIL (P/N 60138) until it is 3/4" from
the top of the tank. Replace the cap on the reservoir. Proceed to remove
the weather caps from each of the plow and vehicle wire harnesses and
connect the plugs. Turn the POWER SWITCH on the joystick in the cab
to the "ON" position and start the vehicle.You now have power to the
snowplow. Once all of the hydraulic functions have been executed, the
system will have been filled with approximately 3 to 3-1/2 quarts of
hydraulic oil.
2. Raise the DRAW LATCH on the snowplow by pushing and holding the
toggle switch on the A-frame upward into the "CONNECT" position. Notice
the action of the fluid in the reservoir. By activating the initial hydraulic
function, the fluid begins to fill the system. Push and hold the toggle switch
in the "DISCONNECT" position, the draw latch will lower. Refill the
reservoir until the fluid is 3/4" from the top of the tank.
3.
Position the vehicle such that the draw latch is below the push beam and
the mounting points on the A-frame are in line with the mounting points
on the undercarriage. Pull out the A-FRAME LATCH PIN and rotate the
A-FRAME LATCH clockwise until the latch is resting on the DRAW LATCH
BOLT MOUNT PIN (See diagram on page 13). Move the snowplow in
position by activating the draw latch CONNECT switch and release.
WARNING: Always use caution when operating the draw latch
®
CONNECT/DISCONNECT switch. Keep your hands and feet
away from the operation of the draw latch and the main blade.
The action of the draw latch moves the snowplow in position
for proper attachment to the vehicle. Failure to follow this
caution may result in serious injury or death.
The draw latch will raise until it hits the push beam and the DRAW LATCH
FINGERS will pull the plow into the vehicle. The mounting points on the
plow and vehicle are now positively aligned. Rotate the A-frame latch
counterclockwise until the latch is in the raised position. Insert the two HITCH
PINS through the mounting holes on the A-frame and secure each with
one hair pin cotter. The snowplow is now securely mounted to the vehicle.
BLZ 1017
4.
Return to the interior of the vehicle. With the plow securely in place, you
can now execute the remaining functions of the snowplow. The power
supply on the joystick should be in the "ON" position. Next, raise the plow
to its maximum height by pulling back ("RAISE") on the joystick. Angle the
snowplow to the left by moving the joystick toward the "L" (left angle) on
the label. If the plow function is slow or delayed, the hydraulic fluid is filling
the cylinder and replacing the air in the system. Continue testing the
remaining joystick functions. Monitor the fluid level in the reservoir and fill
to 3/4" from the top of the tank if needed. Also, look for any automatic
transmission fluid leaks around the manifold, pump, hydraulic hoses and
all cylinders.
5.
Lastly, check that the vehicle and plow headlights are in proper working
condition including the turn signals. If necessary, adjust the plow head-
light beams with the plow in the raised position.
Congratulations on a successful assembly and installation! Once all of the
blade and electrical functions have been tested your Blizzard straight blade is
ready for action. Should you need additional support during a plow assembly
or undercarriage installation, contact your local Authorized Blizzard Dealer or
our Customer Service Department toll free at 1-888-680-8600.
Advertisement
