Dometic FreshJet3 Series Installation Manual page 20

Installation
e e
q q
22 Confirming the foam divider height measurement
Flat surface of the ADB
q
Stack of foam dividers
w
5. Place the ADB face down on a stable, protected, flat
surface.
6. Stack the foam dividers required and place them onto
the ADB.
7. Measure the full height, from the flat surface of the
ADB to the top of the foam dividers to confirm the
full height is equal to the previously determined roof
thickness.
8. Adjust the number of foam dividers to reach the
correct full height, as necessary.
20
w w
Full height
e
measurement (equal
to the roof thickness)
Rooftop air conditioner (air distribution box, wall thermostat controls)
q q
23 Passing the wire through the filter notch
Filter
q
Filter notch
w
9. Slide out the filter to expose the filter notch.
10. Pass the 2-pin lighting cable (if equipped) through
the filter notch.
e e
w w
2-Conductor light cable
e
EN