Panasonic CF-S10CDHZ1M Operating Instructions Manual page 25

Starting Up and Sleep and Hibernation Mode
[Enter Password] does not
appear when resuming from
sleep hibernation.
When logging on (e.g.,
resuming the computer),
audio is distorted.
Cannot resume.
Other startup problems.
Shutting Down
Windows does not shut
down.
Password
Even after entering the pass-
word, a message appears
requesting to type it again.
Cannot log on to Windows.
("The user name or password
is incorrect." is displayed.)
Display
When the screen becomes
black for a moment.
No display.
Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility
( Reference Manual "Setup Utility").
The Windows password can be used instead of the password set in the Setup Utility.
A Click (Start) - [Control Panel] - [User Accounts and Family Safety] - [Add or
remove user accounts] and select the account, and set the password.
B Click (Start) - [Control Panel] - [System and Security] - [Power Options] - [Require
a password on wakeup] and a check mark for [Require a password].
Perform the following steps to change the audio settings to prevent audio output.
A Right-click the desktop and click [Personalize] - [Sounds].
B Remove the check mark from [Play Windows Startup sound], and click [OK].
One of the following operations may have been carried out.
• In sleep mode, the AC adaptor or battery pack was disconnected, or a peripheral was
connected or disconnected.
• The power switch was slid for four seconds or longer to forcibly turn off the computer.
Slide the power switch to turn on the computer. Data not saved will be lost.
Check to see if there was a disk error.
A Remove all peripheral devices including an external display.
B Click (Start) - [Computer] and right-click [Local Disk (C:)], and click [Properties].
C Click [Tools] - [Check Now...].
• A standard user needs to enter an administrator password.
D Select the option in [Check disk options] and click [Start].
E Click [Schedule disk check] and restart the computer.
Start the computer in Safe Mode and check the error details. (
does not start up".)
Remove all peripheral devices.
Wait one or two minutes. It is not a malfunction.
NumLk to disable the ten-key mode, and then input.
If lights up, press
Caps Lock to disable the Caps Lock mode, and then input.
If lights up, press
The user name (account name) includes an "@" mark.
If another user account exists:
Log on to Windows using another user account, and delete the account that
includes "@". Then create a new account.
If no other account exists:
You need to reinstall Windows (
When you set [Display power saving function] of Power Plan Extension Utility to
[Enabled], if you do the following operations, the screen becomes black for a moment,
but this is not a malfunction. You can use it.
• Adjust the brightness of the screen with
• Remove and insert the AC adaptor.
While you are using motion video playback software, benchmark software for graphic, if error
screen is displayed or application software does not function normally, set [Display power sav-
ing function] to [Disabled].
The external display is selected. Press
until the display has been switched completely before pressing
again.
The display is turned off by the power-saving function. To resume, do not press the direct
selection keys, but press any other key like
The computer entered sleep or hibernation by the power-saving function. To resume,
slide the power switch.
The screen may become darker. Press
page 22 ).
Fn + F1 / Fn + F2 .
Fn + F3 (or + P) to switch the display. Wait
Ctrl .
Fn + F2 to make the screen brighter.
page 24 " Windows
Fn + F3 (or + P)
25