Lincoln Electric SAF-FRO DIGISTEEL 355S Operator's Manual page 11

Output Connections
Refer to points [2], [3] and [4] of the figures below.
Controls and Operational Features
1
2
3
Figure 1.
1. Power Switch ON/OFF (I/O): Controls the input power.
Make sure the power source is properly connected to
the mains supply before turning power on ("I").
2. Negative Output Socket for the Welding
Circuit: Depending on the configuration of
power source, for connecting a work lead, the
electrode holder with lead or the source/wire feeder
welding cable.
3. Positive Output Socket for the Welding
Circuit: Depending on the configuration of
power source, for connecting a work lead, the
electrode holder with lead or the source/wire
feeder welding cable.
4. Control Receptacle: 5 pins receptacle for wire
feeder or remote controller connection. To
communication wire
controller with power source is used CAN
protocol.
5. Gas Connector: For connection a gas hose from
interconnecting cable.
6. Quick Connect Coupling: Coolant inlet (takes
warm coolant from torch/gun).
7. Quick Connect Coupling: Coolant outlet
(supplies cool coolant to the torch/gun).
English
4
5
6
7
feeder or remote
11
12
16
17
18
15
8. Supply Plug: for gas heater kit (see "Accessories
Suggested" chapter).
9. Power Lead (5m): Connect the supply plug to the
existing input cable that is rated for the machine as
indicated in this manual, and conforms to all applicable
standards. This connection shall be performed by a
qualified person only.
10. Gas Connector: For connection a gas hose from
cylinder.
11. Swivel bracket: For mounting the wire feeder.
12. Top Chain: To protect gas bottle.
13. Bottom chain: For properly securing the gas cylinder.
Not using both chains at the same time to secure the gas
cylinder may result in damage to the cylinder, the device
and personal injury.
14. Gas hose: For connection between the cylinder and
machine.
15. Mass welding cable.
16. Cover bracket: To intall COOL ARC
and control cable (see "Accessories Suggested"
chapter).
9
8
9
10
19
1
14
Figure 2.
WARNING
®
26 power supply
English