Installation - AEG ProSteam 7000 User Manual

Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex‐
cept where the low voltage equipment has no pro‐
tection against moisture
Water supply
Water supply pressure
2)
Maximum wash load
Maximum dry load
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your do‐
mestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the bottom of the water storage tank.

5. INSTALLATION

WARNING!
Refer to Safety chapters.
5.1 Unpacking
WARNING!
Remove all the packaging
and the transit bolts before
installing the appliance.
WARNING!
Use the gloves.
1. Remove the external film. If
necessary, use a cutter.
2. Remove the cardboard top and the
polystyrene packaging materials.
1)
Minimum
Maximum
Cotton
Cotton
Synthetics
Maximum spin speed
IPX4
Cold water
0.5 bar (0.05 MPa)
10 bar (1.0 MPa)
8.0 kg
5.0 kg
3.0 kg
1400 rpm
3. Remove the internal film.
4. Open the door and remove the
polystyrene piece from the door seal
and all the items from the drum.
ENGLISH 9