AEG ProSteam 7000 User Manual page 41

16.9 Cleaning the drain pump
WARNING!
Disconnect the mains plug
from the mains socket.
Regularly check the drain
pump filter and make sure
that it is clean.
Clean the drain pump if:
• The appliance does not drain the
water.
• The drum does not turn.
• The appliance makes an unusual
noise because of the blockage of the
drain pump.
• The display shows the alarm code
.
WARNING!
• Do not remove the filter
while the appliance
operates.
• Do not clean the pump if
the water in the appliance
is hot. Wait until the water
cools down
Proceed as follows to clean the pump:
1. Open the pump cover.
1
2. Place a suitable bowl below the drain
3. Open the chute downwards. Always
4. Turn the filter 180 degrees in anti-
5. When the bowl is full of water, turn
6. Repeat the steps 4 and 5 until the
7. Turn the filter anti-clockwise to
2
pump access to collect the water that
flows out.
keep a rag nearby to dry up any
water spillages when removing the
filter.
clockwise direction to open it, without
removing. Let the water flow out.
the filter back and empty the
container.
water stops to flow out.
remove it.
ENGLISH 41