Cleaning the Unit
3
Clean the image sensor cover with the
roller cleaning paper.
Then remove the dirt on the sensors,
reflectors and double feed detectors
with the included blower.
≥ When cleaning the bottom image sensor
cover, do not touch the tip of the plastic
pointer (black) in the back of the unit.
If the paper path selector is set to the
lower side, it may cause an injury.
Paper path
selector
≥ The image sensor covers may be very hot
after scanning a lot of documents.
Never touch the image sensor covers or
surroundings directly.
4
Close the front door.
≥ Push both sides of the front door down
slowly until it clicks into place.
26
Pointer
Skew sensor
Starting sensor
Pointer
Image sensor
cover (B)
Left side view
Paper jam sensor
≥How to clean the sensors, reflectors and
double feed detectors
Remove the brush from the accessory blower and
blow off the dirt with the blower.
Sensor or detector
Waiting sensor
Double feed detector
Skew sensor
Image sensor
cover (F)
Reflector
Paper sensor
Double feed detector
Reflectors
Reflector
Blower