Table of Contents
Advertisement
Introduction and Installation
Installing the door station
1
Loosen the mounting screw, and then remove the mounting base.
2
Install the mounting base to a wall using the attached wood screws.
(4 mm x 20 mm,
Important information:
On the bottom surface of the door station, there are holes to allow water to drain.
Do not cover it up when installing.
8
" x
").
3
/
13
/
16
16
Mounting base
Wall
<Installation size>
Note:
• Install so that picture range will be within a height of
995 mm ~ 1795 mm from the ground surface.
Screwdriver
Wood
Screws
Advertisement
Table of Contents
