Problem With Results - Bosch WGA144XVEG User Manual

en Troubleshooting
Fault
Loud noises during the spin
cycle.
Banging noises, rattling in
the drain pump.
Slurping, rhythmical suction
noise.

Problem with results

Fault
Creasing.
Detergent or fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Detergent residue on the
damp washing.
50
Cause
The appliance feet are not
fixed.
Transit bolts have not been
removed.
Foreign bodies have got into
the drain pump.
The drain pump is active, the
detergent solution is
pumped out.
Cause
The spin speed is too high.
The load is too large.
The wrong programme is se-
lected for the type of fabric.
Too much detergent/fabric
softener in the detergent
drawer.
A low spin speed is selected.
⁠ Easy Iron is activated.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
troubleshooting
Secure the appliance feet. Aligning
▶
the appliance
Removing the transit bolts
▶
→ "Cleaning the drain pump",
▶
Page 41
Not a fault – normal operating
▶
noise.
troubleshooting
The next time you run a wash cycle,
▶
set a lower spin speed.
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 23
When dosing liquid detergent and
▶
fabric softener, observe the mark-
ing in the detergent drawer and do
not dose above this.
The next time you run a wash cycle,
▶
set a higher spin speed.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 23
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the ⁠ Rinse programme.
▶