Simple Stacking Conditions; Setting Up Simple Stacking - Epson EB-PU1006W User Manual

Related references
Additional Projector Software and Manuals

Simple Stacking Conditions

You can use the simple stacking feature under the following conditions:
• All of the projectors are the same model and the optional external camera is installed on each
projector.
• Wait for 2 minutes after turning on all of the projectors before starting the simple stacking process.
• You are projecting on a matte white diffusion screen that is flat and even.
• All of the projectors are installed parallel to the screen.
• Nothing is blocking the optional external camera and the projected image.
• The projection size is within the following range according to the brightness of the light source (when
the screen luminance is 40 lux or less):
• Up to 9.9 Klm: 50 to 200 inches (127 to 508 cm)
• 10 Klm: 60 to 300 inches (152 to 762 cm)
• All of the projectors are projecting images at the same resolution.
• The luminance ratio on the screen surface when projecting on an all-white screen and when projecting
on an all-black screen is 8:1 or more.
• The Projection setting for all projectors is set to Front or Front/Ceiling.
Parent topic:
Related references
Optional Equipment and Replacement Parts
Projector Setup Settings - Extended Menu

Setting Up Simple Stacking

You can create a bright projected image by overlapping the images of up to 6 projectors.
1. Connect two projectors using a LAN cable.
Note: For EB-PU2010B/EB-PU2010W, you can also connect the projectors using an SDI cable.
2. Turn on the projectors.
3. Make sure the DHCP setting is turned on in the Network Configuration menu on all projectors.
Simple Stacking for One Bright Image
211