POSITION Menu
Aspect ratio depend on signals
Press I H to cycle through the aspect ratio
options. The cycle pattern depends on the
connected signals.
VIDEO/
S-VIDEO
PC (RGB)
HDMI
COMPONENT
(YP
P
)
B
R
WSS
WSS (Wide Screen Signalling) detects if a
PAL/625p (576p)/625i (576i) signal is input and that
signal has an identification signal, and switch the aspect
ratio to required setting automatically. You can switch
the system off manually.
36 - E
NGLISH
4:3 \ 16:9 \ 14:9 \ JUST \
ZOOM1 \ ZOOM2
AUTO \ 4:3 \ 16:9 \ JUST \
ZOOM
NTSC signal
4:3 \ 16:9
4:3 \ 16:9
VGA or SVGA signals
Not switchable
WIDE480/600/720/768/768-2/800
/900 signals
4:3 \ 16:9
16:9 \ H - FIT \ V - FIT \
ZOOM
1 125 (1 080)/50i,
1 125 (1 080)/60i,
1 125 (1 080)/50p,
1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p
and 750 (720)/60p signals
4:3 \ 16:9 \ JUST \ ZOOM
525p (480p) and 625p (576p)
signals
4:3 \ 16:9 \ 14:9 \ JUST \
ZOOM1 \ ZOOM2
625i (576i), 625p (576p)
AUTO \ 4:3 \ 16:9 \ JUST \
ZOOM
525i (480i), 525p (480p)
16:9 \ H - FIT \ V - FIT
1 125 (1 080)/50i,
1 125 (1 080)/60i,
1 125 (1 080)/50p,
1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p,
750 (720)/60p signals
OVER SCAN
If the 4 edges of an image is partly dropped, you can use
this function to adjust and project it properly.
Shrink
Setting range: 0 to +10
OVER SCAN is not available with PC signals.
KEYSTONE
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface, you can vertically correct keystone.
Image
Setting range: -32 to 32
NOTE:
You can correct the distortion ± 30 degrees from
the vertical plane. For a better quality image,
installing the projector with a minimum of
distortion is recommended.
Some distortion may be retained for Lens shift
adjustment.
The distortion of the Main menu screen is not
correctable.
The result of the keystone correction will affect the
aspect ratio and the size of the image.
AUTO SETUP
You can adjust V - POSITION, H - POSITION, DOT
CLOCK and CLOCK PHASE automatically when
connecting via PC. Press ENTER to adjust these at the
same time.
Enlarge
Operation