Table of Contents
Advertisement
GENERAL SAFETY INFORMATION CONTINUED
WARNING
This product must be properly grounded.
CAUTION
Do not install this recessed luminaire where interior room temperature
may exceed 104 °F (40 °C).
Make sure that the electric service supply voltage is AC 120 V, 60 HZ.
Follow all local electrical and safety codes, as well as the National
Electrical Code (NEC) and the Occupation Safety and Health Act (OSHA).
Always disconnect the power source before working on or near the
light fixture or junction box.
Protect the supply wiring from sharp edges, oil, grease, hot surfaces,
chemicals or other objects.
Do not kink the supply wiring.
Provide make up air for proper ventilation.
For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
Do not install the unit where ducts are configured as shown
in Fig A.
Not for use in cooking area. (Fig B)
The special-purpose or dedicated parts, such as mounting fixtures,
must be used if such parts are provided.
The productmustuseLEDlamp (model:11BR30G4DIM/927/GU24)
fromthecompanyGreenCreative.
Please wear gloves when installing or cleaning this recessed luminaire.
DESCRIPTION
This Panasonic recessedluminaire model is listed by UL under UL file No. E484859.
The trim ring is a spring-loaded, quick remove type. A damper for preventing air counterflow is
provided.
The lighting product is a lighting device that uses one 11 W BR30 shape LED lamp (model:
11BR30G4DIM/927/GU24, from the company Green Creative) and produces almost the same
illumination as a standard 65 W incandescent lamp.
FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning this
product on and off, the user is encouraged to try to correct the interference by one of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect equipment into outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Prohibited
Extreme
bending
Bend
Prohibited
repeatedly
Duct
Prohibited
narrow
Adaptor
Prohibited
Bend near
adaptor
Fig A
(Cooking area)
Do not install above
or inside this area
Floor
Cooking
equipment
Fig B
3
Advertisement
Table of Contents
