Table of Contents
Advertisement
WIRING DIAGRAM
INSTALLATION (BETWEEN JOISTS MOUNTING)
IMPORTANT
Remove the tape from damper and adaptor before
installation. As shown below:
Joist situation:
Spacing A is 12 inches
(305mm) to 24 inches
(609mm) on center joists
If recessed luminaire only is used for lighting,
please remove the damper and adaptor (first move
them down, then move them forward), then use
the adaptor panel to cover the hole of recessed
luminaire. (Fig. 1)
Please follow the installation steps as below (based
on the product with damper and adaptor):
1. Insert the suspension brackets into the luminaire
body from each side of the bracket cover. (Fig. 2)
If spacing A between center joists is 12 inches,
cut all suspension brackets along the two "C"
cuts with a hacksaw or other tools.
2-"C" cuts
2. Fix suspension brackets and
(ST4.2X6), but remember not to tighten the
screws up yet. (Except that the spacing is 12
inches between joists.) (Fig. 2)
3. Position the luminaire body between joists, and
hold it properly. Mark the long holes of all the
four suspension brackets on joists. (Fig. 3)
White
LED lamp
Black
Junctionbox
Adaptor
Tape
Damper
Joists
Before
After
with screws
Neutral
White
Live
Black
Earth ground
Hole
1
2
Damper and
adaptor
Adaptor panel
Unit: inches (mm)
Adaptor
(ST4.2X6)
Screw
Long hole
Gloves
Joist
Luminaire
body
Joist
Suspension
bracket
Ceiling
Unit: inches (mm)
Fig. 1
Suspension
bracket
Suspension
bracket
Bracket cover
Fig. 2
UP
Suspension
bracket
>1/8 (3.2)
Fig. 3
5
Advertisement
Table of Contents
