Locating And Leveling; Installation Of Legs Or Castors - True TFP-72-30M-D-2 Installation Manual

TRUE
refrigerated prep
INSTALLATION OF CASTORS OR
OPTIONAL LEGS
Important Safeguard for installation of leg/castor. Images 1-5 demon-
strate procedure.
SECURING CASTORS AND LEGS
To obtain maximum strength and stability of the unit, it is important
that you make sure each castor is secure. Optional legs are hand-
tightened securely against the lower rail assembly see image 4-5. The
bearing race on the castor or the top edge of the leg must make firm
contact with the rail.
LEVELING SHIMS
Four leveling shims have been provided for leveling castored units
positioned on uneven floors. Shims must be positioned between rail
end and bearing race.
A. Turn the bearing race counter-clockwise until the cabinet is
level. Level front to back and side to side. (diagonally)
B. Install the desired number of shims, making sure the slot of the
shim is in contact with the threaded stem of the castor. See
image 2.
C. If more than one shim is used, turn the slot at a 90° angle so
they are not in line.
D. Turn the bearing race clockwise to tighten and secure the
castor by tightening the anchoring bolt with a 3/4 inch open-
end wrench or the tool provided. See image 3.
CAUTION: TO AVOID DAMAGE TO LOWER RAIL
ASSEMBLY, SLOWLY RAISE UNIT TO UPRIGHT
POSITION.
NOTE: OPEN HOLES LOCATED ON THE CROSS
MEMBERS OF THE FRAME RAIL SHOULD BE
PLUGGED BEFORE UNIT IS IN USE.
5
1
Thread castor into the underside of
cabinet frame rail.
3
Use the tool provided to tighten the
castor into place.
5
The end of the leg is adjustable for
easy leveling.
Lower Rail
Assembly
Rail End
Snug Fit
Here
Leveling Shim
Leg
.
www truemfg
2
For leveling, insert the shim between
castor and frame rail.
4
Thread leg into cabinet bottom
frame rail.
Lower Rail Assembly
Rail End
Castor
.
com
Snug Fit
Here
Bearing
Race