Panasonic KX-TG7431 Operating Instructions Manual page 24

Programming
An alarm sounds once at
Once
the set time. Enter the
desired month, date, and
year. i {OK}
An alarm sounds daily at
Daily
the set time.
3
Set the desired time. i {OK}
4
{V}/{^}: Select "Tone/Melody" or
"Voice". i {SELECT}
5
{V}/{^}: Select the desired item. i
{SAVE}
L If you set a tone or melody, we
recommend selecting a different
one for outside calls.
6
{OFF}
L When the alarm is set, E is
displayed.
Note:
L To stop the alarm, press any dial key
or place the handset on the base unit
or charger.
L When the handset is in use, the alarm
will not sound until the handset is in
standby mode.
L If the talking alarm clock is set at the
same time for two or more handsets,
the first handset makes the
announcement, while the other
handsets only sound the tone.
L If the other unit is in use at the set
time, the handsets sound the tone
instead of the selected
announcement.
L If you select "Once", the setting
changes to "Off" after the alarm
sounds.
24
For assistance, please visit http://www.panasonic.com/help
Call block (Caller ID
subscribers only)
This feature allows the unit to reject calls
when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted ("Storing unwanted callers",
page 24).
– the unit receives a call without phone
number ("Block calls without phone
number", page 25).
When a call is received, the unit rings for
a short time while the caller is being
identified. If the unit recognizes the call
as unwanted, "Caller blocked" is
displayed and the unit sends out a busy
tone to the caller, and then disconnects
the call.
Important:
L When the unit receives a call from a
number that is stored in the call block
list or a call without a recognized
phone number, the call is logged in the
caller list (page 28) with $ after the
call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call block list by using the caller list or
by entering the numbers directly.
Important:
L You must store the phone number
with an area code (10 digits) in the call
block list.
■ From the caller list:
1
{MENU} (center of joystick) i
{#}{2}{1}{3}
2
{V}/{^}: Select the entry to be
blocked. i {SELECT}
L To edit the number, press
{EDIT} repeatedly until the
phone number is shown in the
10-digit format.