Telephone settings
Flash time
The flash time depends on your telephone
exchange or host PBX. Each line has its
own setting.
You can select: "90ms" (milliseconds),
"100ms", "110ms", "250ms", "300ms",
"400ms", "600ms", or "700ms" (default).
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press
{Select}.
3
Scroll to "Set tel line" by pressing
{V} or {^}, then press {Select}.
4
Scroll to "Set flash time" by
pressing {V} or {^}, then press
{Select}.
5
Press {V} or {^} to select the desired
line.
6
Press {V} or {^} repeatedly to select
the desired setting.
7
Press {Save}, then press {OFF}.
Note:
L The setting should stay at 700 ms unless
pressing {FLASH} fails to pick up the
Call Waiting call.
L If the unit is connected via a PBX, certain
PBX functions (call transferring, etc.)
may not work correctly. Consult your
PBX supplier for the correct setting.
For assistance, please visit http://www.panasonic.com/consumersupport
Programmable Settings
Line mode
The line mode for both lines is preset to "B"
and generally should not be adjusted. If
k and l on the handset are not
displayed properly when another phone
connected to the same line is in use, the
line mode selection is incorrect. Set line
mode to "A".
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press
{Select}.
3
Scroll to "Set tel line" by pressing
{V} or {^}, then press {Select}.
4
Scroll to "Set line mode" by pressing
{V} or {^}, then press {Select}.
5
Press {V} or {^} to select the desired
line.
6
Press {V} or {^} repeatedly to select
the desired setting.
7
Press {Save}, then press {OFF}.
39