Table of Contents
Advertisement
4
One-Touch Dialer
4-A Storing a Phone Number in the DIRECT Button
You can store a phone number in the (DIRECT) button. The stored number
is dialed with a one-touch operation.
The TALK indicator light must be off before programming.
(DIRECT)
TALK Indicator
(TALK)
PROGRAM
AUTO
•If a pause is required for dialing, press
counts as one digit (5-D).
(PAUSE)
4-B Dialing a Stored Number in the DIRECT Button
Press
(TALK)
•If your line has rotary or pulse service, any access numbers stored after
pressing (TONE) will not be dialed.
To erase a stored number: press PROGRAM
Special Features
5-F FLASH Button
Pressing
(FLASH)
as transferring an extension call or accessing special telephone services
(optional), such as call waiting.
Selecting the flash time
The flash time depends on your telephone exchange or host PBX. You can
select the following flash times: "90, 100, 110, 250, 300, 400, 600, 700
msec (milliseconds)", using the handset near the base unit. Your phone
comes from the factory set to "700 msec".
The TALK indicator light must be off before programming.
Press PROGRAM
\
.
(FLASH)
•If 3 beeps sound after programming, a wrong key was pressed. Start
again from the beginning.
•If you are connected via a PBX, a longer flash time may be necessary to
use PBX functions (transferring a call, etc.). Consult your PBX installer for
the correct setting.
,
\
(DIRECT)
allows you to use special features of your host PBX such
\
Dialing button (
á
(1): 90 msec (2): 100 msec (3): 110 msec
(4): 250 msec (5): 300 msec (6): 400 msec
(7): 600 msec (8): 700 msec
1
Press PROGRAM
•The TALK indicator flashes.
2
Enter a phone number up to 22
digits.
•If you misdial, press PROGRAM á,
and start again from step 1.
3
Press
(DIRECT)
•A beep sounds.
(PAUSE)
.
á
to
(1)
(8)
Section 4
.
á
.
where needed. Pressing
\ AUTO
\
Ü
Section 5
\ AUTO
)
Ü
.
(DIRECT)
\
Advertisement
Table of Contents
