Making Calls
If noise interferes with the conversation
Press Ü to select a clearer channel in the talk, intercom or remote
operation mode, or move closer to the base unit.
To redial the last number dialed on the handset
Press
or
To adjust the receiver volume (HIGH, MEDIUM or LOW)
or speaker volume (6 levels) while talking
To increase, press
While using
•Each time you press Ñ
(HIGH, MEDIUM or LOW).
Your phone comes from the factory set to level MEDIUM.
While using
•Each time you press Ö
Your phone comes from the factory set to level 3.
•When you replace the battery, the selected receiver/speaker volume setting will
return to the factory set. Reprogram if necessary.
To put a call on hold
Press
(HOLD/INTERCOM).
•The TALK/MUTE indicator and the IN USE/CHARGE/HOLD indicator flash.
•If you put a call on hold for more than 6 minutes, an alarm tone will sound. The
call will be disconnected after a total of 10 minutes.
To release the hold
Lift the handset, or press
•If another phone is connected on the same line (p. 46), you can also release the
hold by lifting its handset.
Lighted handset keypad
The handset dialing buttons will light when you press a button or lift the
handset off the base unit. They flash when a call is received with the
handset off the base unit.
The lights will go out a few seconds after pressing a button, lifting the
handset, answering a call, hanging up a call, leaving the programming
mode or ending the intercom.
22
and press
(REDIAL/PAUSE)
. To decrease, press
Ñ
or
Ö, the volume level will change among 3 levels
or
Ñ, the volume level will change among 6 levels.
or
.
.
Ö
.