Panasonic KX-TG2214F Operating Instructions Manual page 41

Problem
Previously programmed
information is erased.
The unit does not display
the caller's name and/or
phone number.
The handset display exits
the Caller List or phone
book.
You cannot page the
handset.
You cannot redial.
"Recharge battery" is
displayed, " " flashes
or the unit beeps
intermittently.
You charged the battery
fully, but "Recharge
battery" is still displayed
and/or " " continues to
flash.
For assistance, please call: 1-800-211-PANA(7262)
Cause & Remedy
• If a power failure occurs, programmed
information may be erased. Reprogram if
necessary.
• You need to subscribe to a Caller ID service.
• Other telephone equipment may be interfering
with your phone. Disconnect it and try again.
• Other electrical appliances connected to the
same outlet may be interfering with Caller ID.
• Telephone line noise may be affecting Caller ID.
• The caller requested not to send his/her Caller
ID information (p. 20).
• If a Caller ID box is connected between the unit
and the telephone wall jack, disconnect the Caller
ID box or plug the unit directly into the wall jack.
• Do not pause for over 60 seconds while
searching.
• The handset is too far from the base unit.
• The handset user is making an outside call or
viewing the Caller List/phone book. Wait until the
IN USE/CHARGE indicator light goes out.
• The handset is in use. Try again later.
• If the last number dialed was more than 32 digits
long, the number will not be redialed correctly.
• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again
(p. 9).
• Install a new battery (p. 8).
Troubleshooting
41