Table of Contents
Advertisement
MAINTENANCE
CHECK ADJUSTING RANGE FOR GUIDE WHEELS
Legend for illustration Z 20015
(1)
Guide wheel
(2)
Slide block
(3)
Stop plate
"X" Adjusting range for track tension
The adjusting range for track tension is the distance "X" between
guide wheel slide block (2) and stop plate (3). Depending on leng-
htening of the track the slide block (2) may come in contact with
stop plate (3). In such a case, it must be ensured that the track
does not become too loose, Depending on track condition, the
removal of one track pad will restore the adjusting range "X". If
necessary contact our Service Department for more information.
Before working on the track adjusting system, relieve all
pressure in the system by opening the pressure relief cock
(5), see illust. Z 20371 on previous page.
NOTICE
If removal of a track pad becomes necessary, it must be
done on both tracks in order to maintain the same length
of both tracks.
During operation, the pressure relief cock (5) must
always be in CLOSED position. Open cock (5) for pres-
sure relieve prior servicing any part of the system, e.g.
removal of a track pad.
WARNING
4.11 EVERY 500 OPERATING HOURS OR MONTHLY
341
Advertisement
Table of Contents
